2004 Hyundai Santa Fe Camshaft Position Sensor Location. Hyundai santa fe owners have reported 1 problem related to camshaft position sensor (under the electrical system category). In this video i'm replacing the camshaft position sensor on a 2003 hyundai santa fe.
Repair Guides Component Location Views (2005 from www.autozone.com
The camshaft position sensor is located on the engine near the camshaft pulley. Where is the cam a sensor located in a 2004 hyundai santa fe. 12 days later my check engine light.
Related Camshaft Camshaft Sensor Location Content.
You can just get your hand above the transfer box to the 10mm securing bolt. Thread the bolts in place and tighten them with a socket. On the 2.4l and 2.7l engines, the camshaft position sensor is located on top of the engine near the ignition coils.
You Should Make Out The Plug With The Wire And See That The Sensor Is Being Mounted With 1 10Mm Bolt.
One problem related to camshaft position sensor has been reported for the 2004 hyundai santa fe. The most recently reported issues are listed below. After doing calibrating to the steering angle sensor couple of times, the esc off light turned on and it gives me code that the sas is not calibrated and it doesn't reset.
Location Of Crankshaft Positioning Sensor In A 04 Santa Fe 3.5 Liter V6;
Where is the cam a sensor located in a 2004 hyundai santa fe. Oil change leading to engine failure; The most recently reported issues are listed below.
An Expert Who Has Answered 20 Questions.
Plug the wire connector into the sensor. 2004 hyundai santa fe i got an oil change and a radiator flush. Where is the cam a sensor located in a 2004 hyundai santa fe.
To See The Crankshaft Sensor And Connector, Look Between The Valve Cover And The Throttle Chambers (Intake Runners) On The Drivers Side, Look Straight Down Toward The Ground… Look For The Sensor With A Black Wire Connector With A Green Tab On The Side, Held To The Engine Block With A Gold Colored 10Mm Hex Headed Bolt.
I need to locate the camshaft position sensor. To remove camshaft position sensor. The cranikshaft postion sensor is located on the front driver's side of the block about 4 inches below the value body cover
