How To Adjust A Poulan Chainsaw Carburetor. Put the chainsaw to work and enjoy! If you turn it over 1/2 turn you may have to go back and adjust the low.
Carburetor for Poulan Chainsaw 1950 2050 2150 2375 Wild from www.ebay.com
First is the idle speed. Clean the air filter before adjusting the carburetor fuel mixture because the mixture will be too rich if you do it with a dirty filter. Similarly, how do you adjust the idle on poulan woodshark?
Tighten The ***** On The Fuel Petcock.
These are just suggestions, others might do it differently. Measure the idle speed if using a tachometer. Controls the engine at high speeds.
Adjusting Poulan Pro Chainsaw Carburetor First, Remove The Air Filter Cover And The Air Filter From The Saw.
Remove the chocks from the rear wheels. Rinse and dry it thoroughly and fix it back onto the chainsaw and tighten the screw that held it. Put the chainsaw to work and enjoy!
Under Each Of The Screws Contains Markings In The Form Of Letters L, H And T.
Set the highest rotation speed on the tachometer with. If your saw starts up well, works both at idle and adding “gas”, but it is hardly worth giving a load to stalls, then the following steps should be taken: Test it out until you get it perfect.
If I Remember Set The Low And High At 1 1/4 Turn To 1 1/2 To Start Out.
To adjust the carburetor idle speed, locate the idle speed screw labeled with a t just above the primer bulb. First is the idle speed. Open the low and high speed jets 1.5 turns.
There Are 3 Small Bolts In The Side Of The Poulan Chainsaw, Turning Which The Model Owner Will Be Able To Adjust The Carburetor.
The first bolt is needed to adjust the motor when operating at low speed, the second. Try 1 and a quarter each if you want but i bet you will have better luck at about 1 3/4 to 2 turns. Similarly, how do you adjust the idle on poulan woodshark?
