Washing Machine Fills With Water Then Stops

First Of All, Check The Locking Device Of The Drum.

Open your washing machine lid and look for the two screws above the switch opening next to the washtub opening. The lid switch assembly prevents the washer from spinning when the lid is open. Setting a new cycle will result in the washer filling up and then nothing else happens;

Therefore, Belt Issues Are Not Relevant For Them.

Lid switch is not initally involved with washer not starting to agitate after filling with water. I have checked belt tension which seems to be ok. It could be with either clean or dirty water.

Many Washing Machines Will Fill With Water While The Lid Is Open, But The Washing Machine.

Make sure both water taps are turned on and the hose screens are cleaned.the washer can/will cycle the water on and off depending on it it thinks the cycle needs more/less cold or hot water. This could cause the machine to fill with water and then stop working. How to fix a whirlpool washing machine that starts and then stops after it fills with water 1.

The Water Inlet Valve Can Also Be Examined For Any Obvious Damage And Checked For Debris That May Be Blocking The Screens Inside The Water Inlet Valve.

There might be some foreign items stuck between the door. If the washer stops filling, then the problem is related to the electrical circuit that controls the valve. I put in a load that i think was too heavy.

The Water Was Flowing Too Slowly.

If the washer continues to fill, then the water inlet valve is defective. If the washer continues to fill, then the water inlet valve is defective. What you need to find out is whether voltage is getting to the motor or not once the water fill has stopped.